Software & Firmware for HAAKE Rheometers & Viscometers
HAAKE RheoWin 4.92.0007 has been released!

Home > Software > CaBER 1 Software > Version 4.5

HAAKE CaBER 1 Software, version 4.512

Download the CaBER 1 software files

Download the following *.ZIP file and copy it to a new empty directory on your hard drive.

Then unzip the *.ZIP file using any suitable unzip program.

To install the software run the setup.exe file.

Please note:

Additional (NiDAQ) software from National Instrument must be installed for the CaBER software to work.
See the manual.

Supported DAQ cards

The CaBER 1 software version 4.512 is for use with the old internal NI PCI-6024E DAQ card only!

This software will NOT work with the new external NI USB-6212 DAQ card.

CaBER 1 instruments that were originally delivered with the NI PCI-6024E DAQ card (and CaBER software 4.x) will also work with the NI USB-6212 DAQ card (and CaBER software 5.x).

Supported Windows versions

The CaBER 1 software version 4.512 will run under the following older Window versions:

Also see the document CaBER Software Windows 7 and Windows Vista.

The CaBER 1 software version 4.512 will NOT run under the following newer Window versions:

In order to make a CaBER 1, that was originaly delivered with the NI PCI-6024E DA card, compatible with Windows 10, both the DAQ card and the CaBER 1 software must be replaced!

CaBER manual

CaBER manual for software versions upto version 4.512.